San Juan 23 mailing list
|Mobile Geographics||MapTap for PalmOS||CelestNav for PalmOS||IQ Booster for iQue 3600||SJ23||links||tides|
This just came to my attention this AM. Since someone just asked how to do this I thought you all might enjoy it.
No offense meant to the person who just asked.
Here is how to stop receiving Listserv mail...
First, ask your Internet Provider to mail you an Unsubscribing Kit.
Then follow these directions:
The kit will most likely be the standard no-fault type. Depending on
requirements, System A and/or System B can be used. When operating
System A, depress lever and a plastic dalkron unsubscriber will be
dispensed through the slot immediately underneath. When you have
fastened the adhesive lip, attach connection marked by the large "X"
outlet hose. Twist the silver- coloured ring one inch below the
connection point until you feel it lock.
The kit is now ready for use. The Cin-Eliminator is activated by the
small switch on the lip. When securing, twist the ring back to its
initial condition, so that the two orange lines meet. Disconnect.
Place the dalkron unsubscriber in the vacuum receptacle to the rear.
Activate by pressing the blue button. The controls for System B are
located on the opposite side. The red release switch places the Cin-
Eliminator into position; it can be adjusted manually up or down by
pressing the blue manual release button. The opening is self- adjusting.
To secure after use, press the green button, which simultaneously
activates the evaporator and returns the Cin-Eliminator to its storage
You may log off if the green exit light is on over the evaporator . If the red
light is illuminated, one of the Cin-Eliminator requirements has not been
properly implemented. Press the "List Guy" call button on the right of the
evaporator . He will secure all facilities from his control panel.
To use the Auto-Unsub, first undress and place all your clothes in the
clothes rack. Put on the velcro slippers located in the cabinet
immediately below. Enter the shower, taking the entire kit with you. On
the control panel to your upper right upon entering you will see a "Shower
seal" button. Press to activate. A green light will then be illuminated
immediately below. On the intensity knob, select the desired setting. Now
depress the Auto-Unsub activation lever. Bathe normally.
The Auto-Unsub will automatically go off after three minutes unless you
activate the "Manual off" override switch by flipping it up. When you are
ready to leave, press the blue "Shower seal" release button. The door will
open and you may leave. Please remove the velcro slippers and place
them in their container.
If you prefer the ultrasonic log-off mode, press the indicated blue button.
When the twin panels open, pull forward by rings A & B. The knob to the
left, just below the blue light, has three settings, low, medium or high. For
normal use, the medium setting is suggested. After these settings have
been made, you can activate the device by switching to the "ON" position
the clearly marked red switch. If during the unsubscribing operation, you
wish to change the settings, place the "manual off" override switch in the
"OFF" position. You may now make the change and repeat the cycle.
When the green exit light goes on, you may log off and have lunch. Please
close the door behind you.
[originally posted to the Serv-U support list; author unknown]
Happy Holidays!, fair winds and following seas.